[Rubber] Eva Foam Textures

EVA foam has a closed-cell skin over an open interior, so the outer face is smooth and slightly rubbery while cut edges expose a visibly porous structure. Both faces belong to the same material.

License

Free for personal and commercial use. No attribution required. Commercial games, film, and client work are all permitted. No credit, no backlink, no permission request needed. You may not resell or redistribute the texture files themselves as a texture pack.

What's in this collection

  • Smooth EVA skin — sealed outer surface with soft matte finish.
  • Cut cell face — exposed pore structure from a sliced edge.
  • Textured EVA — embossed anti-slip pattern used on mats and decking.
  • Worn EVA — compressed and scuffed areas from repeated pressure.

All tiles are seamless in both directions and delivered at high resolution.

Where EVA foam is used

Cosplay and prop builds. Armour panels, weapon shells and helmet liners.

Sports and gym environments. Interlocking floor mats and padding.

Packaging inserts. Tool cases, camera bags and protective trays.

Marine and outdoor. Boat decking and non-slip step pads.

How to use these in Blender

  1. Load the map into Base Color and keep Metallic at 0.
  2. Set Roughness around 0.7 with slight variation from the texture.
  3. Add a small Subsurface value so thin foam edges soften light.
  4. Use a shallow bump for the skin and a stronger one for cut faces.

How to use these in Unreal Engine 5

  1. Import at 2K and tile 2–4 times per metre for mats.
  2. Use Subsurface Profile for thick foam props under strong light.
  3. Add a compression mask so pressure areas are darker and smoother.
  4. Keep specular low; foam has almost no highlight.

How to use these in Unity

  1. Create a URP Lit material with Smoothness below 0.2.
  2. Assign the anti-slip normal at full strength on decking variants.
  3. Use vertex colour to vary tone between interlocking mat tiles.
  4. Enable GPU instancing for repeated mat sections.

Tips for EVA foam specifically

Cut edges are the identity of this material. If every face uses the smooth skin, the prop reads as moulded plastic.

EVA colours are flat and saturated because they are dyed through. Avoid gradients across a single panel.

Compressed foam stays compressed. Add permanent dents where straps and weight sit, rather than uniform surface wear.

Browse the collection

Rubber textures are organized into volumes, each containing multiple packs. New volumes are added continuously.

View the full Rubber collection →

Related: Plastic, Fabric.

Comments

Popular posts from this blog

[Alpha] Stain Textures

[Mask] Scratch Textures

[Abstract] Textures Hub